Matching Original Hardwood Floors

Thickness height of flooring and sub floor most houses in westchester have solid hardwood flooring which is 3 4 thick.

Matching original hardwood floors.

Matching the new floors to the old is imperative to give the house a complete look. Matching an existing color is a lot harder than sanding all of it and then staining it all the same color. Matching the new materials to the profile of the old flooring boards isn t necessary. Sometimes if there is not a lot of existing hardwood flooring it is just best to take up the old flooring and start from scratch.

This thickness known as a wood s profile should match that of the flooring in other rooms to ensure a seamless look for the viewer. The new boards should be slightly thicker. In such instances matching new hardwood perhaps to an addition to the home a room previously floored with carpet or tile or to a heavily damaged area is a bit more complicated but definitely worth it in most cases. Here are the factors to consider when matching existing and new hardwood floors.

Then consider as per other comments a. Install the other areas raw unfinished and then have it all sanded at the same time and stained to match. To make your floors match make sure that you install site finished hardwood floors in the new room and then refinish the old floors at the same. And if you re lucky original hardwood floors underneath the bad.

You could consider first sanding back and refinishing the existing timber floors with an acrylic based finish that will be more neutral in tone and likely much easier to match in with tonally. After the new floor is installed the profile is reduced by sanding. An original farmhouse sink under a layer of dust in the basement perhaps or a good as new cast iron tub in the master bath. Instead consider having a custom mixed stain matched to the same.

When hardwood flooring coverage is expanded it s not always necessary to sand and stain both the preexisting and newly covered areas at the same time.