Matching Patched Hardwood Floors To Existing

If you are planning to install wood floors in only one area of your home you may be tempted to try to match the floors that are installed in your other areas.

Matching patched hardwood floors to existing.

Then pry out the damaged section. In many cases if you re dealing with an older or pre existing floor there may simply be no way to recreate the perfect match. They look completely different. If the floorboard is very long and most of the board is in good condition cut out the damaged section of the flooring with a circular saw set to a depth exactly equal to the thickness of the finished flooring.

But what if you want to add hardwood floors to a room next to a room with existing hardwood floors. This is very difficult to do because different series of the same types of wood flooring may be slightly mismatched in their tone. Use the wood floor repair technique shown below for short sections of boards. Last but not least check the thickness and height of your current wood floors.

Commonly used in doorways to camouflage rough cuts made where two different installations of hardwood flooring meet t molding features a narrow channel which slides between two gaps in wood then masks the area with a slightly rounded or square piece of trim which sits nearly flush to the existing floors. Match your wood floors throughout the home to unify each room. Also called lacing or threading the boards this is a way to blend existing and newly installed hardwood flooring in areas where you are looking for a seamless transition. Refinishing will make your old floors cohesive again.

The thickness of hardwood flooring boards is known as the profile and profiles vary. T molding is used to bridge gaps in hardwood. The standard is 3 4 inches thick but you want to make sure any new pieces are consistent with the existing floor. Although they were done approx 8 months apart my existing floors and newly installed floors were applied the same stain jaco grey custom and same finish water based satin.

To do this you will of course need to match the species cut width and preferably length of boards as closely as possible. Matching new and old flooring. If the subfloor is the same in both rooms connecting the two rooms with an even floor.