Getting past a mercury engineer is no easy task.
Mercury water pressure gauge not working.
Controls and gauges that have to face the ultimate test.
Posted 10 16 2009 03 38 pm et us on my 180 dauntless with a mercury 115 fourstroke i have replaced the water pressure gauge.
Faria 12828 euro trim gauge for mercury mariner 3003 343 4 3 out of 5 stars 30.
From time to time this feature will get clogged with debris weeds and gravel.
Non critical service engine soon.
Faria 13003 coral water pressure gauge kit 30 psi 2 4 5 out of 5 stars 11.
Non critical service engine soon.
I unhooked the line at the motor and blew it out with an air compressor to be sure there was.
I had to use a mirror and a flashlight to view it.
Any help is appreciated i have a 2010 ranger z521 powered by a 2009 yamaha 250 hpdi series 2.
228 engine sensor shift pressure sensor is not working properly.
My water pump gauge quit working last month.
This problem is easy to fix with one simple tool.
Mercury water pressure gauge not working.
I used canned air to blow it through.
And worthy of your boat.
Speedometers are unique in that some of them use physical cables instead of sensors so a speedometer not working can also indicate a broken cable or stripped gear.
Get it as soon as thu oct 8.
Get it as soon as thu oct 8.
The old gauge was hung on 7 psi.
Your outboard has a water pressure speedometer located on the lower unit of your motor.
Non critical service engine soon.
Shift pressure sensor is not working properly.
Free shipping by amazon.
An individual gauge doesn t work.
229 engine sensor shift pressure sensor is not working properly.
Locate the tiny hole on the leading edge of your lower unit.
Water came out next i looked inside the hose connection on the motor side.
Free shipping by amazon.
If the oil pressure coolant charge or gas gauge doesn t work or works erratically the problem is in the gauge wiring or sender.
I brought it to the dealer they said the gauge was bad so i ordered a new gauge from ranger still under warranty i replaced the gauge still not working.
Often up to 1 000 total hours before the control or gauge is fully certified by mercury engineering.